Drive shaft installation kit

With this kit, you can easily install drive shafts with a press fit in the wheel bearing splines – even in cases where the thread for the axle nut does not protrude through the wheel bearing.


This is made possible by the thin yet very strong adapter sleeves (M16x1.5 to M30x1.5), which fit inside the splines of the wheel bearing and provide correct positioning and engagement of the adapter
during installation.
 
The result is a controlled and safe installation – eliminating the risk of damaged boots or drive shafts caused by hammering, as well as preventing damaged threads often resulting from installation using the original axle nut.

Two working methods – adapted to your needs

1. 01–00062 – Manual installation
   Used together with standard hand tools for a simple and controlled installation.
   
   
2. 01–00062–050 – Hydraulic installation
   For faster and more ergonomic work, the kit is used together with hydraulic cylinder 03–00015 (8.5T). This provides increased efficiency, reduced physical strain, and shorter working time – ideal for high-volume workshops.

Benefits

• Installs drive shafts even without protruding threads.
• Minimizes the risk of damage to components.
• Thin and strong adapter design for optimal access.
• Faster and safer workflow.
  
• Delivered in a foam

01-00062 Contains these parts:

1. 01-00001-203 - Press pipe Ø44,7*
2. 01-00062-001 - Press pipe Ø44,7-39 mm*
3. 01-00062-002 - Adapter M16x1,5 - M14*
4. 01-00062-003 - Adapter M18x1,5 - M14*
5. 01-00062-004 - Adapter M20x1,5 - M14*
6. 01-00062-005 - Adapter M22x1,5 - M14*
7. 01-00024-001 - Adapter M24x1,5 - M22
8. 01-00024-002 - Adapter M27x1,5 - M22
9. 01-00062-008 - Adapter M30x1,5 - M22*
10. 09-000111 - Spacer 28x14,5x3 400HV*
11. RES4010 - Adapter M22-M14*
12. RES4016 - Drawbar M14, 250mm, 12.9
13. 01-00001-401 - Press lid 45 mm
14. RES4021 - Flange nut M14

See also 01-00062-050 contains *1-11 and 03-00047-014 Pull nut. To be used with 03-00015